Gentlemen,

Thank You for the information.

David

"Bruce Ferguson" wrote in message .com...
Fred's idea is a good one. You can use the same idea for a screw chuck if
it is too long. I have several that I can stack of on the screw to shorten
it as much as I want.

Bruce

"Fred Holder" wrote in message
...
Hello Dave,

Lyn did a good job of describing the new 5" Nova. I purchased one while I
was
in New Zealand in March and April of this year. It is one powerful chuck
with
tremendous holding power. Mine is the earlier version with only two holes
to
take all of the current Nova chuck jaws. I expect to get a new set of jaw
slides
to upgrade my chuck to the three screw version of the Titan that Lyn has.

On your second question, I'm not familiar with the Powermatic 3520
spindle, but
is sounds like it is longer than normal. The rear of the Chuck insert
should
mate with the machined shoulder at the rear of the spindle to ensure that
it
runs true. A work around that I've used many times is either machined
washers or
home made washers out of a good hard wood like Holly. I turn the wood
round in
the spindle mode and drill a 1-1/4" hole through the wood. Then I
carefully face
off the end of the wood and carefully part off a washer about 3/16 to 1/4
inch
thick, making sure that the parting tool is sharp and goes in straight.
Slip
this washer onto the spindle, then screw on the chuck. Tighten the chuck
and
check to make sure it runs true.

Fred Holder
http://www.fholder.com/

In article , Dave says...

I am thinking about buying the new Nova 5" chuck. Has anyone used one
and how does it perform?

My current Nova chuck doesn't tread all of the way on to my
Powermatic 3520 spindle, it bottoms out when the spindle contacts the
chuck body but there is still about 1/8" before the chuck insert
contacts the spindle shoulder. Is this normal?

Thanks,
Dave