View Single Post
  #21   Report Post  
Posted to rec.crafts.metalworking
Michael A. Terrell Michael A. Terrell is offline
external usenet poster
 
Posts: 12,924
Default Adding vibration to lathe cutting tool to aid cutting


Larry Jaques wrote:

On Thu, 12 Jun 2014 10:34:05 -0400, "Michael A. Terrell"
wrote:


Jim Wilkins wrote:

A steady stream of Bozons cycled through the job of Production
misManager. The nameplate by the door was a chalkboard.

The interview test was to have them pick up a screwdriver. Grabbing
the blade end qualified them for management.



The next test was with a hot soldering iron. The ones that picked it
up my the element were qualified for upper management.


You have -videos- of this, I hope? vbg



I wish! It would go viral in a hurry.


--
Anyone wanting to run for any political office in the US should have to
have a DD214, and a honorable discharge.

---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com