Thanks Rusty,

Dave


"Rusty Myers" wrote in message
.. .
I just measured my s750 lathe and stand. It is 28" x 36". If you add in
motor overhang, then 28" x 46". That is with the bed in closed position.
Since the legs flare a little bit in the front and back, that dimenison
would increase slightly if you raise the stand (adjustable legs) or
decrease
if you lower it. You need to add another 6" of clearance for the knockout
bar, plus about 18" for the bed being extended for the maximum it takes
up.
I have mine with the headstock towards the wall and the tailstock in the
middle of the room. That gives me plently of room to work around that
end.

--
Rusty Myers
Austin, TX