On Sun, 16 Mar 2014 19:49:36 +0000, polygonum
wrote:

On 16/03/2014 16:46, Gordon Henderson wrote:
In article ,
MM wrote:
It's leaking around the spout where it joins to the can. I don't think
it's possible to solder a galvanised can, or is there some approach I
could take? I don't have access to brazing gear. New cans are quite
expensive and this can is fine, apart from the leak.

Sugru?

Gordon

Article about Sugru in the Guardian:

http://www.theguardian.com/business/...dhulchaointigh

It's not cheap though!