wrote in message
...
On Saturday, February 15, 2014 3:55:25 PM UTC-5,
Phil Kangas wrote:
Guy showed up here the other day asking if I

could repair the table lead screw nuts for a

RF mill drill. ;)} They are brass and one was

stripped out and the other was almost there.

http://www.rongfu.com/en/milling-drilling-machine.html

With the internet, it is quick to contact the
manufacturer.

Nook industries has 3/4 -10 Bronze nuts but does
not show 7/8 -10 on their web site.

http://www.nookindustries.com/Produc...Category/1100#

Just curious are they both right hand thread?

Dan
The nut and shaft I had in hand was right hand
thread. The book he
had for it showed the same part number for both x
and y, so, assuming they
are the same. The book had a date of 1991 on it...
I'll send him the addy above and hope for the
best. So far, I've
turned down the job.