Thread
:
More Actual Woodworking and another use for the Domino
View Single Post
#
29
Posted to rec.woodworking
Leon[_7_]
external usenet poster
Posts: 12,155
More Actual Woodworking and another use for the Domino
On 2/7/2014 2:46 PM,
wrote:
On Fri, 07 Feb 2014 08:21:10 -0600, Leon lcb11211@swbelldotnet
The through holes are exact width 5mm mortises, directly on top, 10mm
exact width, plunged about 3/16" .
Hmmm. I haven't used my 10mm Domino bit yet. Your 10mm bit slot looked
bigger than I thought it would have looked.
You know, the 10 mm slot is twice as wide as the 5mm slot. ;~)
And of course the slot is going to be 5mm wider/longer.
One other question. I haven't tried a through hole with the Domino
yet. Do you use a backer board when doing a Domino through hole?
I did not for those pictured and I did have a bit o tear out on the back
side. None of this is going to ever show so I was not concerned.
And I was thinking that the bit might finally be getting a bit dull.
Today I made 16 more through slots and had not one tear out. I suspect
it was the orientation, vertical, that I was holding the Domino and did
not have a real stable hold on it yesterday. I probably wiggled a bit.
Today the Domino was cutting horizontally.
Reply With Quote
Leon[_7_]
View Public Profile
Find all posts by Leon[_7_]