"Upscale" wrote in
t.cable.rogers.com:

"Lobby Dosser" wrote in message
news:vfUMc.7771

Running a 4'x8' sheet of plywood through a table saw at a 45 degree
angle sounds pretty dangerous. But then, running it through straight
calls for serious concentration.

Not at all if it's done properly. A simple angle guide and proper
placement of an outfeed table makes it very simple. But, forget about
the 4x8 sheet. What about simple mitres on smaller stock? As far as
I've seen, a panel saw is not capable of such cuts.




Don't know why not. Just calls for a different design than the norm. You'd
have to clamp the stock to a variable angle tray.