Leon wrote:
On 1/10/2014 2:52 PM, Bill wrote:
Leon wrote:
I have started a job for a customer, 2 walnut curio cabinets.

What they should look like,

http://www.flickr.com/photos/lcb11211/11863453395/

Leon, It appears that you will ... snip Am I close, or would it
be better for me to wait
for the picture (providing you are willing to share that information)?

Bill


Ok, yes, the front/back face frames and side panels will be joined by
a rabbet joint running along the length of the front and back face
frames sides.
Probably SOP to you, quite "clever" to me!

The square assembled unit will be held square and reinforced by the
dadoed in 3/4" thick plywood bottom. Each side has a dado in the
bottom rails to accept the bottom panel.

Nice (and efficient) way to help get structural integrity.


Often a picture is worth a thousand words.

This shot shows the dados at the bottom of the front/back face frames
and the rabbet on the side edges. Clocked 90 degrees in the picture.

http://www.flickr.com/photos/lcb1121...n/photostream/

The first, back face frame, in the picture shows the inside side of
the back face frame. The next face frame, in line, is the outside
side of the back face frame. Notice that I used lap joints to form a
recess for the back panel to fit into. these joints are reinforced
with 5mm Dominoes.

The next two face frames are the front face frames. Nothing special
with the joinery on those except that they are butt joints reinforced
by Dominoes.

The backs of the side panels, dry fit before inserting the panels and
glue up.

Now if you noticed that none of the face frames and or side panels
bottom rail dado's go through the side stiles, I later completed the
dado's on both ends on all face frames and side panels. I cooked up a
unique way to cut those out accurately, cleanly, and quite quickly.
I could have cut the dado's in the stiles before assembly but
alignment would have had to be perfect. Cutting them after glue up
insures perfect alignment.

Here is a shot of the completed dado's that the bottom will fit into.
I have also applied the first coat of varnish to the inside sides
before assembly. This really makes varnishing the inside of the
cabinet easier.


http://www.flickr.com/photos/lcb11211/11888682455/


Thank you very much for providing a lesson! I don't think Michael
Fortune could do any better. I'm always impressed when I see wonderful
techniques, and maybe I shouldn't be so surprised when they are
revealed, but that keeps me coming back for more!

Bill