How to sharp inside corners
Ollie wrote:
We had to make some L-shape pieces from 1/2 in plywood. We did use the
table saw for the outside dimensions (2' x 2'). Table saw was used for most
of the length (around 11") for the two lines towards the center. The last
inch was cut with a jig saw. Obviusly the result was not as good as with
table saw. To smoothen the last part we did use a stationary 12" sander.
There must be an easier way to get the nice inside edges. What is that?
I think I might have used a router instead of jig saw, then a
corner chisel to remove the inside fillet left by the router.
--
Morris Dovey
DeSoto, Iowa USA
|