On 12/28/2013 10:22 AM, Michael Black wrote:
On Sat, 28 Dec 2013, amdx wrote:

I parted out a flat screen TV, I pulled an inductor off a board. The
inductor is about 3" long and an inch in diameter. It is wound with a
litz type wire and the value is 5.6uH.
I'm curious, what was the use of this coil. It seemed to carry a
pretty heavy current, because it was mounted with 4 pins on each end
and all four pins were connected to the litz. Also the solder joints
to all the pins were over heated.
So, in what circuit would this be used.

Thanks, Mikek

The trick is to keep the boards intact until you need the parts, then
the context helps reveal information about the part.

Michael


I have boxes of boards, I'm just curious about the use of this
physically large inductor.

Mikek