Removing Freely Rotating Swaged Steel Pin
"DoN. Nichols" wrote in
:
On 2013-12-27, Doug White wrote:
snip
I strongly doubt that the crazy glue will be strong enough, even
if you could get it into the holes between the pin and the walls.
Before I drag out the Dremel, does anyone have any better sugestions?
You have what I would try, at least.
It looks like you can remove that linkage assembly from the
action by removing C-clips, so you won't be juggling as heavy a bunch
of metal, and controlling it will be easier.
Good Luck,
DoN.
This seems to be the concensus. I'll check out my countersink supply &
see what I can find. The swaged bit is quite shallow. If I start out
small and drill with ever increasing drill bits, hopefully I can open it
up without the countersink slipping.
Doug White
|