Thread
:
Removing Freely Rotating Swaged Steel Pin
View Single Post
#
14
Posted to rec.crafts.metalworking
KG[_3_]
external usenet poster
Posts: 9
Removing Freely Rotating Swaged Steel Pin
On Thu, 26 Dec 2013 17:20:35 -0800 (PST),
wrote:
On Thursday, December 26, 2013 8:18:08 PM UTC-5, wrote:
On Thursday, December 26, 2013 7:32:06 PM UTC-5, Doug White wrote:
The collegiate pistol team I help coach has two Russian target air
pistols that have broken cocking linkages. I have replacement parts,
but I need to disassemble a linkage that has a swaged pin in it. The
ends of the pin are even with the sides of a piece I need to rescue
undamaged. I had originally planned on drilling/milling out the center
of the swaged part enough to press the pin out, but I discovered that
the pin is free to rotate. There's nothing exposed enough to hang onto
that I don't need to largely cut away.
I can probably grind out the swaged bit VERY carefully with a Dremel,
but it's going to be tedious & fussy.
The pins are about 5/16" in diameter, and each end has a shallow drilled
out section. It looks like they pressed ball bearings into the ends to
spread them. The linkage the pin goes through is countersunk on both
sides, so the swaged bits hold everything together.
There a picture he
http://www.pyramydair.com/blog/image...inkage-web.jpg
The pin is the large one with the dimple just left of center in the
image.
The only way I can think of to physically hang onto the pin is to make
an expanding collet that goes into the drilled out pocket on the far end
of the pin. That is going to be tenuous at best, and it's a lot of work
to fabricate for a high likelihood of failure.
One other option would be to crazy glue everything together, mill out
the swaged bit, and then soak it in acetone until the pieces free up.
That assumes the crazy glue can handle the machining forces.
Before I drag out the Dremel, does anyone have any better sugestions?
Thanks!
Doug White
If you can tolerate the pin spinning in the hole perhaps quite a bit I've found drilling rotating pins works if you angle the piece, idea is to angle the part so the drill spins the pin but off-center, on 'average' there will be a part where the bit is hitting where the bit surface speed will be larger than the pins.
Maybe you could CA or loc-tite a small metal rod in the drilled end and clamp the rod in the vise?
Dave
BTW CA gets gummy and lets go at a fairly low temp if you get tired of waiting for acetone to do its thing.
Another suggestion is to mount 2 drills in a lathe, place the center punched pin
between them and slowly turn it. One or both drills will intermittently grab and give
you a hole that you may use an easy out in to allow you to drill out the other end.
Please let us know what works.
To reply to this message please remove the AT
after the kgs1 in the reply to address.
To a conservatist's it truly is a free country,
YOU may do whatever they wish. KG
Reply With Quote
KG[_3_]
View Public Profile
Find all posts by KG[_3_]