On Thu, 31 Oct 2013 09:19:44 -0500, Ignoramus17776
wrote:

On 2013-10-31, Stormin Mormon wrote:
On 10/31/2013 12:21 AM, Ignoramus22345 wrote:
On 2013-10-31, Gunner Asch wrote:

Either in the head or in the motor


Makes a lot of sense

Is it possible to detach the two, scrape the
firemen out of the grease cup, and run the
motor alone? Put the firemen and the cutting
head back one at a time.

Is the tool big enough for zerks, or is it
perma lube? Some spray oil here or there, may
give you a quick diagnosis.


I tried turning the spindle by hand, and I did feel some un-evenness
in the bearings.

i

If you can feel it..time to replace the bearings. Shrug

Gunner

--
"Their mommies tell them they're special, Liberals just don't understand
that "special" is a polite euphemism for;
*window licker on the short bus*"

---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com