Noisy T&C grinder head
On 2013-10-31, Stormin Mormon wrote:
On 10/31/2013 12:21 AM, Ignoramus22345 wrote:
On 2013-10-31, Gunner Asch wrote:
Either in the head or in the motor
Makes a lot of sense
Is it possible to detach the two, scrape the
firemen out of the grease cup, and run the
motor alone? Put the firemen and the cutting
head back one at a time.
Is the tool big enough for zerks, or is it
perma lube? Some spray oil here or there, may
give you a quick diagnosis.
I tried turning the spindle by hand, and I did feel some un-evenness
in the bearings.
i
|