On Wed, 30 Oct 2013 19:52:21 -0500, Ignoramus22345
wrote:

I have a particular tool and cutter grinder. Its head is noisy, in
fact, its noise resembles the sound of a rotary siren (though not as
loud). Would you say that the most likely cause of it is bad bearings?

Either in the head or in the motor

Gunner

--
"Their mommies tell them they're special, Liberals just don't understand
that "special" is a polite euphemism for;
*window licker on the short bus*"

---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com