On 10/19/2013 06:52 PM, Ignoramus23452 wrote:
On 2013-10-19, Ignoramus23452 wrote:
I have a 3/4" thick steel plate that is 3/4" thick. It is bowed in the

Sorry. I just came home from a little party, that's why I mis-wrote
some things.

5x10 ft plate that is 3/4 inch thick.

middle along its length. The worst un-straightness is in the middle
and it is appx. 1/4". I would like to straighten it. How can I
realistically do it, if at all.

To add to that, I can somewhat deflect this plate using jacks and
chain.

Does it need to be clean on both sides? If not, a couple of weld
beads run across the convex side should pull it back straight.
Shouldn't take much.

--
Bob Nichols AT comcast.net I am "RNichols42"