On Sunday, 12 September 2010 18:40:35 UTC+10, Peter wrote:
Any one happen to have one of these handy work centres ?? I am trying to
track down a replacement stick on type ruler measuring thingy. I have tried
here in Australia, with no luck. So if i have to buy from you guys over the
the USA, then so be it.

Any one who could swap ideas too, would be appreciated.

Peter
Queensland, Australia

I printed my own ruler on normal laser paper, stuck it down with double sided tape (the thin stuff). Then I coated it with clear two pack epoxy. works fine.

the PDf is here http://snk.to/f-ctiq70qi

I printed on a hp laser @ 1200 dpi, and it's accurate to at least 1 line thickness, which is better than my (old) eyes.!

hope someone finds this usefull.

Mark