On Sun, 15 Sep 2013 11:36:32 -0500, -MIKE-
wrote:

On 9/15/13 11:29 AM, Ivan Vegvary wrote:
Need to cut short pieces of 2x4 (12" length) with ends cut at 60
deg. angle on the flat. These will tuck up under the peak of the
attic so the drywall installer can make a small soffit. Portable saw
only goes to 45 deg. Same with table saw. I could stand pieces on
end and slide them along the fence. Sounds dangerous. Need to do
about 60 cuts. Advice appreciated.


I not sure exactly what you're attempting to do but can't you just cut
them square and nail them to the side of the roof rafters to give you
the drywall soffit?
--
Jack Novak
Buffalo, NY - USA