DIYbanter - View Single Post - Wiring for multiple control [4 switches control one set of lights]light switch !!!

Bud--

On 6/18/2013 7:03 AM, wrote:

But I see in another post that you want to see the
switch position to tell if it's on or off. These use
a push paddle type of system, so there is no toggle
switch to look at. It might have an LED indicator
though that shows when it's on. Not sure about
that. Probably does though, because if you
have 6 of these Lutron dimmers it would be good to
know at each one that somebody has turned the
light on. When I'm back at the house I will check for
you.

Along the lines of "LED indicator", I believe an old thread had a 3-way
switch with a pilot light. There was a resistor from each traveler to a
common point, with the pilot light from the common point to the neutral.
The common point would be 120V with the lights off and 60V with lights
(incandescent) on. Could do the same thing with a 4-way, and the
manufacturer probably did. (Switch lights up with the lights off.)

Can't do what the OP wants - multiple control positions with switch that
turned the light on in the up position. Actually you could by wiring all
single pole switches in parallel and the switch(es) that are 'up' turned
the light on, but not a useful solution.

Closest may center off, momentary contact up and down switches, as in
your post, where you don't have 'chaotic' random up and down switch
positions.

Lots of descriptions of 3-way, 4-way switches on the internet which the
OP should look at if he hasn't figured out how his switches work.