On Wed, 05 Jun 2013 17:03:20 -0700, Larry Jaques
wrote:
On Wed, 5 Jun 2013 08:54:24 -0700 (PDT), Stanley Schaefer
wrote:
On Jun 4, 10:10*pm, Larry Jaques
wrote:
I have to retain some little LED panels to a flat surface. *The 3M
doublestick adhesive foam is proving to have less than stellar
performance after they warm up for awhile.
I sourced these panels from China and none of the sellers have any
clue for bezels. *I don't think their translators handled that
conversation very well. *sigh
http://www.homeandgardenhandyman.com...PanelSizes.jpg
Retainer depth of about 3mm.
Opening for LEDs: 52-55mm W x 36-36.5mm
Qty needed: 1 dozen.
Budget for this project: $10. *
--
A mind, like a home, is furnished by its owner, so if
one's life is cold and bare he can blame none but himself.
* * * * * * * * * * * * * * * * * * * * *-- Louis L'Amour
Have you looked a the usual suspects for such, like Mouser or Digi-
Key? Even Jameco had them decades back. Probably more like $10@,
though. $10 will just about get you a roll of aluminum tape and an
Xacto knife...
Thanks, Stan. I hadn't thought of those sources and will check with
'em.
Mouser, DigiKey, Allied Electronics, All Electronics - all NOGO.
Jameco website under construction, site down. (really stupid, huh?)
PRDproducts.com has potential. Email sent.
Thanks again, guys.
--
I have never understood why it is "greed" to want to keep the money you
have earned, but it is not greed to want take someone else's money.
--Thomas Sowell