Arfa Daily wrote:
So the week got off to a great start. I've got a Dual CS505-3 phono deck on
the bench. It all works hunky-dory, except it's a bit slow. This is because
the pitch belt has snapped. So I'm pulling a new one into place, and the
pliers catch the flat leaf spring that couples the speed select knob to the
belt shifting lever. It only holds in there because it's bent and under
tension. And of course, it detaches and flies ...

I have combed every square inch of the floor under light strong enough to
burn your eyes out, but nope, it's gone ...

So now, I've got a deck that is 33 or 45 rpm only, depending on where you
leave the belt shift lever set. I've sent an email to the company
responsible for Dual products in Germany, pleading for them to help me out
with a replacement, but I'm not holding my breath. About the only other
alternative is to try and fabricate one. I've spotted an old octal based
relay where the moving contact fingers look big enough, but the length is
absolutely critical to get the right spring 'snap' action of course, and I
don't think it is going to be easy to achieve that ...

Don'cha just HATE it when **** like this happens :-\

Arfa

not sure about your spring, but lots of weird dual parts turn up on ebay.

I had a c-clip fly away not long ago, so I ordered a new one, that was the
wrong size, then a week later the original one appeared again.