Put lathe screws in the dimples of self-furring lathe?
DD_BobK wrote:
On May 13, 8:13 am, "Bob F" wrote:
DD_BobK wrote:
that's because most people using this self-furring lath are not
privy to the thinking that went into its design.
IME most self-furring lath (esp the pre-papered stuff) is installed
incorrectly but that's the typical result because the typical
installer isn't trained, doesn't understand the concept & is in a
real hurry.
Finally! Someone used the correct word. Cood work!
Bob F-
What word?
Lath. Lathes are just to hard to nail to the wall.
|