On 4/27/2013 2:58 AM, wrote:
On Fri, 26 Apr 2013 10:52:15 -0500, Leon lcb11211@swbelldotnet
Can be made to fit almost any existing router table. Open up the possibilities for new router profiles!
http://www.youtube.com/watch?v=9a88f1pv6jM

Very cool and well thought out fence you got there Brian..... If that
thing was aluminum...... you might be the next competitor with Incra!

+1. I could see it selling very well.


Sorry, but I don't. I would think a tilting router base would work
better. The gap at the bottom shows no support and that is a minus.

Sorry Brian, I didn't mean to rain on your parade. But support is
everything, so is contact, its good, but not great.

I have seen tilting router supports for sale, and a nice home made from
Matthias. I would not use the gear that he used, but I might use the
screw drive that he had, just coupled differently.

--
Jeff