We had kitchen cabinets installed Thursday. There were two floor to ceiling
cabinets installed, one on each side of the refrigerator. There is a bridge
wall cabinet to connect the two 'floor-to-ceiling' cabinets.

A base (toe-kick) was set in place, the one-piece cabinet placed on top,
leveled and plumbed and mounted to the wall. The bridge cabinet was
installed next, then the second 'floor-to-ceiling' cabinet. Trim molding
covers the remaining approximate 3/4-inch between the base+cabinet and the
ceiling.

good luck with your installation,

Jack


"Bob" wrote in message
...
I am in the final design phase of my new kitchen cabinet design and am
just about ready to start cutting some wood.

In looking at my drawings I noticed that I may have a potential issue
that I could really use anyones advice on.

I have a built-in refrigerator cabinet that goes from floor to ceiling
(96"). If I built this cabinet, then tried to get it into position, I
dont think I would be able to stand it up (since I have 96" ceilings).
No way to lean it up.

(deleted remaining text)