On 2/13/2013 1:15 PM, Pat Barber wrote:
On 2/13/2013 9:30 AM, basilisk wrote:


It would be used as a handheld, the milwaukee looks good, it goes to the
top of the list. Wanting a large router is more about duty cycle than the
actual load per cut. Intended use would be to cut about 8, .5" deep X
1.75" wide dadoes across 4" stock a minute, if the job became higher
volume, then custom
machinery would be brought into play.

Wouldn't a table saw with a dado blade be much faster ???

That would be 24 passes assuming you put a dado set on there that is
just over 3/4" wide. I think I have seen 13/16".