COst of steel at metal suppliers
On 2013-02-12, Tom Gardner Mars@Tacks wrote:
On 2/12/2013 4:24 PM, Ignoramus2009 wrote:
On 2013-02-12, Tom Gardner Mars@Tacks wrote:
On 2/11/2013 9:19 PM, Ignoramus22507 wrote:
On 2013-02-12, Tom Gardner Mars@Tacks wrote:
On 2/11/2013 6:56 AM, Ignoramus22507 wrote:
On 2013-02-11, Tom Gardner Mars@Tacks wrote:
On 2/10/2013 8:19 AM, Ignoramus2110 wrote:
I did not see any D-2, but I have a big block of O-1.
What are the measurements and weight?
6x3x44, appx 223 lbs
How many brushes of what kind do you want for it?
Special rec.crafts.metalworking price is $1/lb. ATM I have a lot of
brushes, we mostly use 4 and 6 inch cup brushes.
i
Let me see what freight would be, can and will you cut it?
Should be about $148 to ship to location with forklift.
Or free pick-up from me.
I am not sure if I can cut O-1, I have a 12 inch bandsaw.
i
Sure! It cuts like CR when soft. D-2 cuts OK too when soft. The O-1 I
heat-treat in house but the D-2 has to be sent out.
I would say, get the whole thing then.
Did you once say you think you had some D-2 round? I need 8-1/4" or so
round to make 1" thick blades with a 4" bore...I used to get hollow bar
but not too many centers can get it anymore.
I thought it was D-2, but it turned out to be 4140 instead. I have a
few more large rounds to look at though.
i
|