On 2/12/2013 5:15 PM, azotic wrote:

"Ignoramus2009" wrote in message
...
On 2013-02-12, Tom Gardner Mars@Tacks wrote:
On 2/11/2013 9:19 PM, Ignoramus22507 wrote:
On 2013-02-12, Tom Gardner Mars@Tacks wrote:
On 2/11/2013 6:56 AM, Ignoramus22507 wrote:
On 2013-02-11, Tom Gardner Mars@Tacks wrote:
On 2/10/2013 8:19 AM, Ignoramus2110 wrote:
I did not see any D-2, but I have a big block of O-1.


What are the measurements and weight?


6x3x44, appx 223 lbs


How many brushes of what kind do you want for it?

Special rec.crafts.metalworking price is $1/lb. ATM I have a lot of
brushes, we mostly use 4 and 6 inch cup brushes.

i



Let me see what freight would be, can and will you cut it?

Should be about $148 to ship to location with forklift.

Or free pick-up from me.

I am not sure if I can cut O-1, I have a 12 inch bandsaw.

i

Cutting torch will do it. Just cut it a couple of inches longer
then tom can trim off the heat affected zone in his saw.

Best Regards
Tom.

OH GOD NO!!! NEVER torch it, you loose too much. It cuts like CR when
soft. I cut it almost every day. But, it's a good thought.