Bill wrote:
Leon wrote:
Bill wrote:
Leon wrote:
I'll send a picture of the real thing too. It is basically 2x4
and 1x4 material.
Leon, I received your file. Thank you very much for sending it!
It was interesting to see the way you
handled the "joinery" for the uprights and that you designated a
spot for each of your parallel clamps.
Thanks for sharing!

Bill
Your welcome Bill. Any time.

Here is what I came up with so far (it took longer than it looks,
lol). If the 2 frames have structural integrity, then it would seem
there will be little to worry about. There is a lot of room for
craftsmanship for knocking oneself out (with stretchers, shelves, etc.).
Do you think there is adequate wood in under the 3/4" plywood "floor
here? I will wrap four lengths of 2by4 around the base that you can
see in the picture.


Structurally Bill, you don't even need the 2x4's under the 3/4" plywood. If
you think about it, the 2x4 risers are carrying all of the weight. Wheels
mounted beneath those will transfer all of that weight to the floor, just as
if the 2x4's went all the way to the floor. The 3/4" isn't going to carry
any load between the 2x4's so it is not succeptable to sag or the likes.
It's not even necessary, except to act as a stretcher for the 2x4's. So -
whatever 2x4 framing you decide to put under it is really a matter of your
choice, not so much one of structural necessity. Go with what you eye
likes.

--

-Mike-