On 1/17/2013 9:24 AM, Bill wrote:

Let me rephrase my question:

My only "fine measuring stick" is a 12" Starrett combination square.

Do I need more tools for setting up an 8" jointer or table saw properly?

Bill



Depending on the quality of your equipment you need to be able to
measure in the thousands of an inch. For example to measure your
TS blade being parallel to the miter slot and the fence parallel to the
blade you are shooting for as close to perfectly parallel as you can
get. Dial indicators which measure much smaller increments helps you
get there especially when setting the miter slot to the blade.
Typically rip fences are very easy to adjust in small increments and
results are easily seen by your eye so in this case I never use a
measuring devise to set the fence parallel to the blade.