On Tue, 04 Dec 2012 15:37:40 -0500, knuttle
wrote:

On 12/3/2012 10:46 PM, Existential Angst wrote:
"Existential Angst" wrote in message
...
"DerbyDad03" wrote in message
...
This guy purposely caused kickback on his table saw to prove a point.

Make sure you watch what happens at 4:20 into the video.

He agrees with anyone who calls him an idiot.

http://www.youtube.com/watch?v=u7sRrC2Jpp4

Excellent vid, valuable lesson.
He's not an idiot, he just didn't have the control over the situation as
he expected. **** happens, even with good intentions.

He proly would not have lost a digit or part thereof (as in a RAS), but he
certainly came close to requiring a lot of stitches, and poss. nerve
damage -- which can be almost as bad as losing a digit.

How does a riving knife work? Never saw one before this.

Apropos of this, the SawStop:
http://www.youtube.com/watch?v=eiYoB...endscreen&NR=1

Am I the only one who would never work with the blade that far above the
wood?

I normally have only a quarter to 3/8 inch of the blade above the piece
of wood. (Higher for harder wood)

If I need to cut a notch..I use the horizontal bandsaw

Gunner

The methodology of the left has always been:

1. Lie
2. Repeat the lie as many times as possible
3. Have as many people repeat the lie as often as possible
4. Eventually, the uninformed believe the lie
5. The lie will then be made into some form oflaw
6. Then everyone must conform to the lie