Hole saw cheaper than ambulance. Call the local hardware stores, and see if
you can rent one. But, that one will probably be dull.

Christopher A. Young
Learn more about Jesus
www.lds.org
..

"DerbyDad03" wrote in message
...
I need to cut a 4" round hole in a soffit, from underneath, while
standing on a ladder. The soffit is not horizontal, it slants upward
from the gutter towards the house.

We may have some access to the soffit from above, perhaps enough to
drive a screw through with a right angle drill to locate the position
on the outside, but I don't think I have enough room to get a jig saw
in there.

My guess is that it will all have to be done from the ladder. I don't
want to spend upwards of $45 for a 4" hole saw and arbor for this one
hole, so I'm looking for creative suggestions from this fine group.

I'm think that I don't want to use a router, upside down, while
standing on a 28' ladder. I'm not even sure a jig saw will be that
easy to use.

The hole will be covered with the cover shown at the link below, so it
doesn't have to be perfect, I just need to feed (and attach) a 4"
aluminum elbow to the hole.

http://cdn.oneprojectcloser.com/wp-c...5/DSC_0135.jpg

Maybe just a series of holes drilled in a circular pattern will be
good enough, but I'd prefer soemthing a bit neater.

Suggestions?