On Jul 12, 12:22*pm, harry wrote:
On Jul 12, 4:20*pm, DerbyDad03 wrote:





On Jul 12, 5:49*am, Ed Pawlowski wrote:

On Thu, 12 Jul 2012 02:18:14 -0700 (PDT), harry
wrote:

On Jul 11, 12:45*am, "
wrote:
On Tue, 10 Jul 2012 18:34:42 -0400, "Grumpy" wrote:
Remove and reveres face of the blade?

It'll still turn the same direction.

"Dick Adams" wrote in ...
The blades on both of my circular saws are spinning
counter-clockwise? *What could have caused this?

Don't feed the trolls.

Not neccessarily a troll. This is a common problem with three phase
supplies.

But I've never seen a three phase hand held circular saw.

I pointed that out to him earlier in the thread. Perhaps he is
ignoring me.- Hide quoted text -

- Show quoted text -

We don't know if it's a bench saw or a hand held saw.- Hide quoted text -

- Show quoted text -

Go back and re-read my earlier post on that subject.

A synopis:

I doubt that the OP has two 3 phase "bench saws", mistakenly called
them "circular saws" - a term typically reserved for hand held saws
only - and also doesn't know that his 3 phase power was recently
altered.

If he really has two 3 phase "bench saws", then he has a fairly
sophisticated workshop and should know if his power has been worked
on.

You'll notice that we haven't heard back from the OP, haven't you?

Methinks it's at best an attempt at humor, at worst a troll.