On Mon, 14 May 2012 09:35:50 -0400, "Michael A. Terrell"
wrote:


Jim Thompson wrote:

On Sat, 12 May 2012 20:17:33 -0400, "Michael A. Terrell"
wrote:


Jim Thompson wrote:

Where do I find this part?....

http://www.analog-innovations.com/SED/RubberFoot.jpg

It's a rubber cabinet foot, made in the style of automotive panel
fasteners... insert into hole, push pin in to lock.


What diameter hole does that fit, and how many do you need? A lot of
computer cases used those, and I have some I saved.

Two sizes needed:

1/4" Qty Needed: 4


I found three this size that look to be the same height as the one
shown. I haven't been to my shop yet, but there should be about a dozen
out there.


19/64" (as near as I can measure :-) Qty Needed: 4


Still looking for these. I know there are a couple junk PCs with
them, in the back of the TBS pile.

I take them off of expensive Agilent gear that is being placed into a
rack.

You'd be surprised what HP and Agilent chassis parts and rackmount
parts go for on E-bay.

I do not sell them there or otherwise. Jus' sayin'.

I have 3 c7000 slide mounts that are easily $150 each on ebay and far
more from HP.