Round frames on router table
On Mon, 20 Feb 2012 10:43:51 -0700, Kevin Miller wrote
(in article ):
On 02/20/2012 05:24 AM, Bruce wrote:
This is my setup for making round art frames for some of my wife's
glasswork.
I'm trying a new design with the grain flowing radially instead of
circumferentially, all to avoid chip out and other routing challenges .
It will be interesting to watch the radially glued frame over time. I
would expect that seasonal expansion and contraction may cause some
issues. It may not, being only a couple inches wide, but worth keeping
your eye on.
Yes, fingers crossed. I went ahead and split the frame into to circles and
did the overlap just in case...
Pretty frames however. I hope they do hold up. I'm sure your wife will
love them. Post a finished shot when you get there...
WillDo.
-BR
...Kevin
|