On 1/19/2012 9:04 AM, Larry Jaques wrote:



Let me explain it this way, imagine putting a drop of super glue in the
head of the screw and letting it cure with the bit inserted. It is that
tight of a fit. Pulling on the drill and bit does not separate
anything. Working the drill and bit back and forth 2~3 seconds finally
works the bit free of the screw. AND that is easier when driving
screws. Removing screws is a bigger problem.

Buy harder screws which don't tend to stick to the bit?



Well I think I am buying pretty hard screws, they seem to never misform
and I almost exclusively use McFeeleys and Kreg screws. I don't want
screws crapping out on me.

On another note and response I mentioned that it may be the heat
generated that causes the screw to tighten up on the driver.