shaper tool holders
On Tue, 17 Jan 2012 17:47:30 +0930, "Kevin(Bluey)"
wrote:
Zero rake lathe tool holders are not common here and very difficult to
find. I guess most of them got tossed out along with the shapers when
mills started to take over.
While zero rake is normal..they will run nicely with a bit of positive
rake, as long as you grind some relief. Hell..they will run with
negative relief if the machine is stout enough.
Gunner, with a 8" Logan and many hours on a 36" Cinci
One could not be a successful Leftwinger without realizing that,
in contrast to the popular conception supported by newspapers
and mothers of Leftwingers, a goodly number of Leftwingers are
not only narrow-minded and dull, but also just stupid.
Gunner Asch
|