"David Looser" wrote in message
...

snip
: I was singularly unimpressed with Italian mains safety. The 10A
plug has 3
: thin pins with no support for the plug other than that provided
by the pins,
: so the plugs tend to hang half-out of the socket due to the
weight of the
: flex. No shutters, no plug-top fuses and in the (modern)
installation I saw
: large numbers of sockets were all wired to a single fuse or
circuit breaker
: of significantly higher rating that of the plug & socket.
:

But how is that any different to some idiot in the UK bridging
out the fuse in a BS1363 plug and then using 3A cable to string a
large number of trailing sockets together, a prospect that has
increased since the introduction of "Part P" in the UK
(especially in hazardous areas such as wet areas and kitchens).

Perhaps you might care to place your comments about Italian
electrical safety into some perspective, if it really is as
dangerous as you claim, would you like to cite a reference for
the number of electrical fires caused by such instillation
practises?

Only the ill-informed or idiots (those without common sense) make
something unsafe. As long as the rating of the socket or
conductor is not exceeded then there is no problem surely. I note
that you failed to specify the cross sectional dimension of
conductor used in these Italian instillations...
--
Regards, Jerry.