On Sat, 03 Dec 2011 03:02:55 -0800, Gunner Asch
wrote:

https://picasaweb.google.com/1040422...15534047903506

https://picasaweb.google.com/1040422...15793966013074

https://picasaweb.google.com/1040422...16686683095186

https://picasaweb.google.com/1040422...16798214073362

Dirty..ugly and nasty..but in surprisngly good shape and very very
little backlash in any axis.

A couple of the switches need replacing, I can do it..or you can do it
for a discount.

It has both vertical AND horizontal spindles and motors.
Everything runs nicely.


$1800 OBO.
Ill even toss in a few 40 taper tool holders and a decent vise (Kurt
Klone)

Located in Chino California.

About 2000 lbs
220vt 3ph

Gunner


This looks like a hell-of-a milling machine. That 40 taper is a HUGE
improvement over R8. Somebody on the left hand side should snap this
up.

Karl