Ignoramus19744 fired this volley
in :

On 2011-12-01, Larry Jaques wrote:
On Wed, 30 Nov 2011 20:36:50 -0600, Ignoramus27667
wrote:

On 2011-12-01, Lloyd E. Sponenburgh lloydspinsidemindspring.com
wrote:
Ignoramus27667 fired this
volley in :

I hate you! Please post some pictures before cleanup!

Will do... picking up tomorrow (unless the old guy must have a
transfusion... in which case Friday)

BTW... OOOOooo! He was a structural steel fabricator... He has
WELDING stuff, too! Ooooo! G

LLoyd

Get all his welding stuff... This is where the money is...

What did you get for your collection of little sans-accessory TIGs,
Ig?


I still have a couple to sell, but 300-600 USD depending on my luck.

I would say 450 average.

That was a great lot. I may keep one suitcase welder for myself.

i


This fella has a whole stack of broken and parted-out Millermatics, but
he wouldn't sell the Syncrowave 250 he had!

The saw looks to be made in the late 1940s or 1950s. It has a more
modern motor, but the right frame type to fit properly.

It has a lot of UGLY all over it, but all the parts are there except the
model number tag (Kalamazoo tag is still there), and the power switch has
a jury-rigged enclosure. All the bearings have been recently replaced
(including the two wheel bearings). I quicky cleaning and a paint job
will put this thing is as-new condition.

It weighs around 1100lb, with about 800 of it on the motor end, so I have
to bolster the floor in my trailer before I can haul it. Those little
steel casters will poke right through (DAMHIKT).

I also now have a 15HP Quincy 3ph compressor (75SCFM) on a 200(or so)
gallon tank in LOVELY condition that I'll sell for $2300, FOB Bunnell,
FL.

LLoyd


Lloyd