On 2011-11-18, Ignoramus4881 wrote:
A flatness gauge?
http://boss-proxy.chudov.com/tmp/tmp-0477.jpg.html
Looks like it -- for checking for worn spots in a surface plate
perhaps? Nope -- not nearly sensitive enough for that. The dial is
calibrated in steps of 0.001" and I think that you would want something
in steps of 10 u" (micro-inch) or perhaps 1 u".
Yes, it will measure flatness, but not to the degree needed for
a surface plate.
Enjoy,
DoN.
--
Remove oil spill source from e-mail
Email: | Voice (all times): (703) 938-4564
(too) near Washington D.C. |
http://www.d-and-d.com/dnichols/DoN.html
--- Black Holes are where God is dividing by zero ---