On 9/28/2011 3:09 PM, -MIKE- wrote:
On 9/28/11 2:51 PM, Father Haskell wrote:
Set the blade to full depth. Runs cooler with less strain
on the motor.

How is that?



less cut being made at a time.

if you have the blade just *barely* through a inch and a half piece,
then you have almost four inches of cut being made. if you have it at
full depth, you are almost straight up and down with the cut and only
making 1- 1/2" at at time.

--
Steve Barker
remove the "not" from my address to email