"Hugh Jass" wrote in message
...
On 9/22/2011 12:44 PM, Frank wrote:
On 9/22/2011 11:11 AM, Tony Hwang wrote:


Frenchie wrote:
I have a few hex screws that i would like to remove. I bought a bit
for my drill at home depot and lost it on the way home. I remembered
that i had an old socket wrench set. Could someone tell me how this
works? I see at the 'head' of the rachet a turning figure, but don't
know its purpose. I assume they work on the same principle of clock
wise and counter clock wise...turning it counter clock wise had no
effect...what is the purpose of that 'turning lever' on the head? I
manipulated it to see if i get any effect, especially counter clock
wise, but there was no friction. Yes, at least i know that i have the
proper size, cause i felt the tension tightening it..
Hi,
Troll!

Either that or incredibly dumb

Prolly one of them Mormons.

WAIT! WAIT! INCOMING PROPHESY .............................