I got one of the Delta jigs, and the metal guide bar was a tad too big
and snug making it a bit hard to slide in the groove of my dad's olds
Craftman TS. I took the metal bar off of the jig and ground some of the
width off using an old grinder that I salvaged from my dads barn /
garage/ shop when we moved him back to the city years ago. That metal
was HARD, but I eventually got it down enough that the jig slided just fine.



BM Cooper wrote:
Hi everyone. I'm trying to determine which after-market tenoning jigs will
work with Craftsman miter slots. I know, I know, everyone is jealous of my
table saw, but it's NOT for sale. (grin) For what it's worth - It's about 3
years old and a (relatively speaking) "higher" end contractor saw (for
Craftsman).

It seems to me that the Delta won't work... Is this true? Any help as to
what might work well would be greatly appreciated.

I'm also looking for advice on a good bench top mortiser. Thanks for your
help! Ben