bad URLs

On 2011-08-31, Al wrote:
Hi all,

Out of room, clearing out stuff. All prices are negotiable:

Everede boring bar holder. I do not know much else about this and have
never used it. It was on my 10" Sheldon lathe when I got it. $35.00 Photo:
http://img.photobucket.com/albums/v4...e/IMG_5522.jpg

Some type of grinder spindle:
Markings on it say: "Whinton Spindle, Division of Mite Corp. Style
311-2114-190, Max RPM 10,500" It has a 2" diameter pulley for a flat
belt on one end and the wheel end is 1.25" diameter and is threaded. It
has two threaded collars to secure the wheel. Body is 3" diameter and
10" long. Spins freely and smoothly but I have never run it up to speed.
It has a 1/8" NPT hole on the side marked "oil mist". It includes a
Norgren F12-300-M3DA filter/oil mist lubricator shown in the photos. No
idea what it originally came off of. $75.00

http://img.photobucket.com/albums/v4...t/IMG_3857.jpg
http://img.photobucket.com/albums/v4...t/IMG_3858.jpg

Accurite DRO scale mount kit for surface grinders:
This is new and in the box. It was purchased and was never used,
hardware is still in the sealed bags. Model number 38-50-48-000, made to
fit Kent,Do-all and other grinder. For a 12" mini-scale, according to
the label. $50.00
http://img.photobucket.com/albums/v4...t/IMG_3888.jpg
http://img.photobucket.com/albums/v4...t/IMG_3887.jpg

Allen-Bradley Size 2 Type 1 motor starter/contactor in enclosu
Used but appears to work and was functional when taken out of service.
Coil is 110V and the contactor actuates when the coil is energized. $25.00
[http://img.photobucket.com/albums/v4...t/IMG_3881.jpg]
[http://img.photobucket.com/albums/v4...t/IMG_3880.jpg]
[http://img.photobucket.com/albums/v4...t/IMG_3882.jpg]

Brown & Sharp permanent magnet chuck. model No.618. Needs a good
cleaning but in decent shape, no dings or grind marks on the surface. 6"
x 18" working surface. The short fence is missing, long one is there.
Magnet has good pull to it, appears to work fine. $100.00

[http://img.photobucket.com/albums/v4...t/IMG_3824.jpg]
[http://img.photobucket.com/albums/v4...t/IMG_3830.jpg]

Two tapered grinder wheel adapters. originally on a Kent 1020, these
Balancing Wheel Adapters have 3.500" taper/foot and are 1.02"dia at the
small end and 1.50" diameter at the large end. These are 4"OD and mount
a wheel with a 2" hole. $40.00 for the pair.

[http://img.photobucket.com/albums/v4...e/IMG_3847.jpg]

All of the above ships from 01826, buyer pays actual shipping cost.
Available for pick up if you happen to be passing by. Feel free to make
an offer on any of this stuff.

Thanks very much!

-AL