On Aug 11, 10:38*pm, wrote:
On Thu, 11 Aug 2011 08:11:05 -0400, "Joe AutoDrill"

wrote:
wrote in message
.. .
I'm restoring a 1964 garden tractor. The shaft for the cone clutch is
17 spline. In all my searching, I only find 16 and 20. The OD measured
0.7550.

Is there a 17 that is standard? Sources? What I actually need is the
interior spline bushing (with or without flange) that slides on the
shaft.

Andy

Do you have a copy of the Machiery Handbook? *It may be in there...

That is one of the places I found 16 and 20 in that OD.

Very likely that it could be a special. We do them all the time.