Circular saw recommendations?
On 8/8/2011 7:37 PM, dpb wrote:
On 8/8/2011 3:48 PM, Leon wrote:
...
Given the way most RAS's are set up, squaring that board might be a bit
more diffident once you actually try that. IIRC the blade is
approximately 30 inches from the end of the table so you have about 7
1/2 feet of board hanging off of the table....
no, No, NO!!!
Like a TS, a good RAS setup is in a table providing infeed and outfeed
support.
If you will reread what I said, given the way "most" are set up...
|