DIYbanter - View Single Post

J. Clarke[_2_]

In article , says...

On 8/8/2011 9:38 AM, J. Clarke wrote:
...

While an RAS, perfectly aligned, is a wonderful tool, bump it in the
wrong place and you have to go through the whole process again. I just
don't get the same repeatability out of the RAS that I do out of a
crosscut sled on the table saw.
...

If a simple bump can do that, it's the POS in "POS RAS" that's the
problem, not that it was a RAS...

It's inherent in the design. Bump the end of the arm from the side and
something's going to give. It's called "leverage".