"Ignoramus14275" wrote in message
...
http://igor.chudov.com/tmp/Cuttermaster/

Don't run the air-bar without air pressure to it, and if it gets sticky then
clean it and the housing bores with acetone and a clean lint-free cloth.

Amway makes a metal polish you can use to polish the bar with if the above
doesn't get it to move effortlessly, clean the residual film off of the bar
with acetone before reassembly and also squirt a small amount into the air
supply.

IMO Cuttermaster is better than Darex by far but neither of them hold a
candle compared to a Weldon unit on a #2 cincy