On Thu, 16 Jun 2011 00:18:37 -0500, Ignoramus16551
wrote:

On 2011-06-15, Gunner Asch wrote:
On Wed, 15 Jun 2011 07:53:57 -0500, Ignoramus10056
wrote:

It took about an hour, but I am finally done, trammed it with a dial
indicator. 0.001" over about 4 inches. (diameter of the circle that
the indicator makes when attached to spindle).

i

Only .001?

Why did you bother? Thats pretty far out.

Mine is trammed at .0003 at 8" and its Almost ok

I could not get it better than that. Spent 10 minutes on that final
adjustment and nothing improved.

i

Then you may have to pull the head and open up the mounting holes a bit
more. Just a smigeon. Ive seen this on more than one miller..usually
Chicom..shrug but one Okuma as well

Gunner

--
Maxim 12: A soft answer turneth away wrath.
Once wrath is looking the other way, shoot it in the head.