On Tue, 14 Jun 2011 04:32:34 GMT, Red Green wrote:

Vic Smith wrote in
:

On Fri, 10 Jun 2011 09:44:54 -0700 (PDT), Bryan Scholtes
wrote:

Maybe it's the tool I bought, but whenever I use my new oscillating
tool I'm just not impressed with it.

Cutting wood takes too long. Cutting metal (cuting nails) takes much
too long versus a Dremel. And it's LOUD.

I bought a Menards-brand Li-Ion cordless model. Is there THAT much of
a difference versus the others? I can't find a review that implies
cheap oscillating tools are necessarily worse than, say, Rockwells.

I know that cheap power tools aren't as good as expensive power tools.
But when I buy Harbor Freight I get about 80% of the effectiveness and
ease-of-use.

I bought a HF multi-tool when I did some remodeling last year.
Basically to cut the door stops near the floor so I could fit
thresholds. Worked fine.

Yes, excellent.

Also worked well for some sanding in tight spots.

Never tried for that.

It's not loud at all.

Working inside, I disagree.

Anticipate using it for cleaning out tile grout and some more sanding.

I've used it for grout but found it very slow. Especially on very old
grout. Crappy HF blades I assume. What literally rips through grout, and
I mean like a few feet per minute, is a Rotozip with a diamond blade.

....and makes a total mess of the tile in the meantime. The bits don't last
long, either. I went through a couple dozen (they're $10 each at the BORG)
doing the surround in my last house.

Otherwise it won't earn back what I paid for it.
It's not for cutting nails or cutting wood except in small amounts.

True. But I have. Having the Original HF-MT, it's only single speed and
burns up blades (blue tip). I did learn to keep a small container of
water and dip it as needed.

You're using the wrong tool.

--Vic


I'm a long time HF- multi tool proponent. My comments to yours are above.